12.4.2. Check and adjustment of height of road gleams
Check and adjustment of height of road gleams of axes
|
Check and adjustment of height of road gleams of axes |
|
Check and adjustment of height of road gleams of axes, - the left back point of measurement |
|
Check and adjustment of height of road gleams of axes, - the left forward point of measurement |
Check and adjustment of height of road gleams of axes
|
- The corresponding illustrative material is presented on illustrations to which all references which are found in the text belong.
- Estimate degree of wear of protectors, replace defective tires.
- Check correctness of pressure of a rating of tires, in case of need make the corresponding adjustment.
- Height of a road gleam of axes of the car is determined by a tilt angle of the lower levers of the corresponding suspension bracket.
- Put a magnetic measuring element (086b) in deepening in the lower lever of a suspension bracket (4).
|
On the models equipped with xenon headlights turn out a bolt (4a) so that it ceased to act from the lever (4). The plate of a measuring element (086b) has to settle down a flute at an angle 90 ° to the direction of the movement. |
- Write down results of measurements for each lever of both suspension brackets.
- Adjustment of height of a road gleam of a forward axis is made by correction of landing of support of the torsion springs.
- Correction of a gleam of a back axis is carried out by means of replacement of screw springs of rack-mount assemblies.
|
|