14.9.1. Removal and installation of groups of electric motors of the drive of adjustment of a front seat
Details of installation of group of electric motors of the drive of adjustment of provision of a pillow of a seat
|
|
- The corresponding illustrative material is presented on an illustration to which all references which are found in the text belong.
- Remove a back of a front seat (see the Head Kuzov).
- Turn out screws (2) on a frame.
- Remove a pillow of a seat (1) from the adjusting mechanism.
- Disunite contact sockets of an electrical wiring of driving electric motors (M25m2 and M25m3).
- Turn out screws (3) basic arms (4 and 5) and remove the last.
- Remove lock rings (6) and take the bearing fingers (7) from heads of forks.
- Turn out screws (8) and remove axial holders.
- Remove electric motors of the drive of adjustment of height of forward (M25m2) and back (M25m3) of edges of a pillow.
- Installation is made upside-down.
- In conclusion check serviceability of functioning of the electric drive.
|
|
Electric motors of the drive of adjustment of provision of a pillow
Details of installation of group of electric motors of the drive of adjustment of an inclination of a seatback
|
|
- The corresponding illustrative material is presented on an illustration to which all references which are found in the text belong.
- Remove a seatback (see the Head Kuzov).
- Remove an overlay of a back (2).
- Having wrung out a frame of a back (3) down, take from it plug-in guides of a slip (1).
- Remove a lock washer (4) axes of the regulator (7), - the washer is subject to replacement without fail.
- Give a nut (6) of fastening of a driving electric motor (M25m5).
- Remove a rubber damper (5).
- Take an axis (7) of the regulator.
- Disunite the contact socket (X54/20) and remove assembly of a driving electric motor (M25m5), - delay a slip (1) from a frame approximately on 10 cm.
- Installation is made upside-down.
|
|
