7.1.7. Removal and installation of the sensor of provision of a bent shaft (CKP)
Details of installation of the CKP (L5) sensor of the engine of a series 111
Details of installation of the CKP (L5) sensor of engines of series 112 and 113
|
|
- Details of installation of the CKP sensor of petrol engines are shown on illustrations, in case of need remove the air cleaner.
- After replacement of the CKP sensor it is necessary to make a reinitsialization of the module of management with use of the special diagnostic equipment, - it is the most reasonable to charge implementation of this procedure to specialists of car service.
|
|
Diesel models
Details of installation of the CKP sensor of the engine of a series 612
|
|
- Details of installation of the CKP sensor of the diesel engine of a series 612 are shown on an illustration to which all references which are found in the text belong
- The car also establish to Poddomkratta it on props.
- Remove the lower section of a noise isolation.
- Disunite the contact socket (1).
- Turn out a fixing bolt (2) and remove the CKP (L5) sensor.
- Installation is made upside-down.
|
|
