12.1.4. Removal and installation of the torsion springs
Details of installation of the torsion springs of a forward suspension bracket
Details of installation of the torsion springs of a forward suspension bracket
|
|
- Details of installation of the torsion springs of a forward suspension bracket are shown on illustrations to which all references which are found in the text belong.
- The car also establish to Poddomkratta it on props.
- By means of Columbus measure spring pretightness size (16a) - at installation the pretightness has to be kept.
- Having turned out a bolt (16s), release a spring bar (16a).
- Release a bolt (16f) of fixing of the profile plug (16e) and shift the last on a bar back.
- Take assembly of the torsion spring from under the car.
- Weaken the screw (16h) and remove a face cover (16g).
- Release the torsion bar (16a) from the persistent lever (16d).
- Installation is made upside-down, - previously grease the knurled site of a bar. Pay attention to the marking (shooter) regulating the provision of a bar (16a) of rather persistent lever (16d). Do not forget to grease a bolt (16s) and to fill the same lubricant its boot (16i). Track observance of initial size of a pretightness of a spring.
- Check correctness of level of landing of the car and the direction of optical axes of headlights, in case of need make necessary adjustments.
|
|
