106fb49f

14.10.7. Replacement of lamps of saloon lamps

Design of the forward saloon lamp


 PERFORMANCE ORDER

  1. The design of the forward saloon lamp is shown on an illustration to which all references which are found in the text belong.
  2. Remove the ceiling console (1).
  3. Take the lamp needing replacement (2).
  4. Having released from clamps, remove from the console panel (1) cartridges of a lamp (3).
  5. Take the switch (4) from a reflector (6).
  6. Turn out screws (5) and, having hooked, carefully release a reflector (6) of the lamp from the console panel (1).
  7. Installation is made upside-down. In conclusion check serviceability of functioning of lamps.

Back lamp

Design of the back saloon lamp


 PERFORMANCE ORDER

  1. The design of the back saloon lamp is shown on an illustration to which all references which are found in the text belong.
  2. Having hooked, cast away a plafonny cover (1), having lowered it against the stop in the limiter.
  3. At the corresponding complete set disunite the contact socket of an electrical wiring of the indicator display of the Parktronic system.
  4. Release assembly of the saloon lamp (E15/3) from a ceiling upholstery, - pull the rear edge of assembly down and at the same time give it forward.
  5. Disunite the contact socket (2) electrical wirings of the lamp.
  6. In case of need remove the failed lamp.
  7. Installation is made upside-down. Make sure of serviceability of functioning of the lamp.