4.4.13. Removal and installation of a flywheel / driving disk
Details of installation of a flywheel / a driving disk on the series 111 engine
|
|
- Details of installation of a flywheel / a driving disk on the engine of a series 111 are shown on an illustration to which all references which are found in the text belong.
- Remove transmission (see the Head the Manual box of gear shifting and Avtomatichekhky transmission).
- On models remove coupling from RKPP (see the Head the Transmission line).
- Install the lock (3).
- Turn out fixing bolts (1).
- Remove a flywheel (86) (single-section, or two-section) / a driving disk (98).
- On models remove a back washer from AT (3).
- Installation is made upside-down.
|
|
Fixing bolts are subject to replacement without fail. |
|
|
M112/113
Details of installation of a driving disk on engines of series 112 and 113
|
|
- Details of installation of a driving disk on engines of series 112 and 113 are shown on an illustration to which all references which are found in the text belong.
- Remove transmission (see the Head Avtomatichekhky transmission).
- Install the lock (6).
- Turn out bolts of fastening of a driving disk (1) to an end face of a pin of a bent shaft (5).
- Remove a washer (2).
- Remove a driving disk (1).
- Installation is made upside-down, - unambiguity of landing of a disk is guaranteed by existence of a cylindrical pin (4).
|
|
Fixing bolts are subject to replacement without fail. |
|
|
