106fb49f

6.1.8. Depletion of the fuel tank

Depletion of the fuel tank according to the standard scheme (petrol models)

1/1 — the Service valve


 PERFORMANCE ORDER

  1. Illustrative material according to the standard procedure of depletion of the fuel tank on petrol models is presented on an illustration to which all references which are found in the text belong.
  2. Dump pressure in a path of a power supply system (see the Section Dropping Pressure in fuel system of the petrol engine).
  3. Disconnect the line of supply of fuel (17/2) from the fuel highway (17).
  4. Connect a fuel hose (80/9) with a diameter about 10 mm which end lower in the prepared drain capacity of suitable volume to the line of supply of fuel (17/2).
  5. Take from the landing nest in the assembly block of the relay of the fuel pump (F1k3).
  6. Establish a crossing point between slots 30 (+ batteries) and 87 (entrance contact of the relay).
  7. Include ignition and wait for the end of discharge of fuel from a tank.
  8. Having finished, restore initial connection of the fuel line, establish to the place of the relay.

The emergency procedure (at the faulty fuel pump), - all models

Depletion of the fuel tank according to the emergency scheme (all models)

Depletion of the fuel tank according to the emergency scheme (all models)

84 — an access window Cover
90/10 — the Line of grounding (the vacuum block)
90/11 — the Line of return of fuel
90/12 — the Line of supply of fuel

90/13 — the Nipple socket of connection
stationary heater (at
corresponding complete set)
90/14 — the Exhaust hose


 PERFORMANCE ORDER

  1. Illustrative material according to the emergency procedure of depletion of the fuel tank is presented on illustrations to which all references which are found in the text belong.
  2. Turn out fixing bolts, raise the rear edge of a dual pillow of a back seat and uncover established on its frame.

Uncover only with documentary identification of A, D and E.

  1. Cast away a pillow forward.
  2. Unbend the floor carpet panel under a basic arm (1) of a frame of a seat forward, also unbend edge of the carpet panel around a slip (2) left racks of Page forward.
  3. Cut through a carpet directly behind a cable of fixing of a seat (3), - try not to damage an electrical wiring (4).
  4. Without bending, cast away a floor mat and, previously a warming up the hair dryer back, uncover a service window (84), - the cover is put on sealant and is subject to replacement without fail.
  5. Clamp or самоконтрящимися nippers press and disconnect the line of return of fuel (90/11).
  6. By means of a transitional nozzle connect an exhaust hose (90/14) to the socket of the returnable line (90/11).
  7. Make grounding of the exhaust pump (90/10).
  8. Start the vacuum pump and pump out fuel from a tank in the prepared capacity.
  9. Installation is made upside-down.