12.3.11. Removal and installation of a steering wheel and spiral contact drum of a steering column
Removal/installation of a steering wheel
Removal/installation of a steering wheel
Removal/installation of a steering wheel
Removal/installation of a steering wheel
|
|
- The corresponding illustrative material is presented on illustrations to which all references which are found in the text belong.
- Disconnect a negative wire from the battery.
- Remove the module of a driver's frontal safety cushion (120) (see the Head Onboard electric equipment).
- Disunite contact sockets of an electrical wiring of a horn (38b and 38s).
- Bring forward wheels of the car into rectilinear situation, then block a steering column by extraction of a key from the ignition lock.
- Holding a steering wheel (32), turn out a bolt (32s), - the bolt is subject to replacement without fail.
- Accurately remove a steering wheel (32), - try not to damage an electrical wiring.
- Check a condition of a spiral contact drum (A45) of an electrical wiring of a horn and a safety cushion, in case of need make its replacement (see below).
- Installation is made upside-down, - track correctness of combination of landing marking.
|
|
Spiral contact drum
Removal/installation of the spiral contact reel
Removal/installation of the spiral contact reel
Removal/installation of the spiral contact reel)
|
|
- The corresponding illustrative material is presented on illustrations to which all references which are found in the text belong.
- Remove a steering wheel (see above).
- Weaken screws (32h) exactly so to provide a possibility of removal of a contact drum (A45), - bolts at the same time play a role of protection against a provorachivaniye.
- Accurately remove assembly of a spiral drum (A45) from a pipe of a shirt of a steering column.
- Disunite the socket (38d) of an electrical wiring of drum assembly (A45).
- Estimate a condition of a drum (A45), - top (32f) and lower (32g) sections of drum assembly strongly fasten to each other by means of clamps. Replace defective components, - try not to allow jammings of a spiral spring (32e) at connection of sections of a drum.
- Installation is made upside-down. Track completeness of landing of a drum (A45), - deepening has to be combined with a lock uvula (shooter), in case of need make centering.
|
|
