13.1.13. Removal and installation of a rear bumper
Details of installation of a rear bumper on models standard (not AMG) complete sets without external holder of a spare wheel
|
|
- Details of installation of a rear bumper on models standard (not AMG) are shown to a complete set without external holder of a spare wheel on an illustration to which all references which are found in the text belong.
- At the corresponding complete set disunite the contact socket of an antenna cable of system of an emergency call (E-call) which is located under a side overlay of the right rack With in a poddomkrachivaniye point.
- Having hooked a suitable wedge, uncover and give nuts (E) and screws (C).
- At the corresponding complete set release a nut of fastening of a mud-chipper.
- Having given back, accurately remove a bumper, - try not to damage a paint and varnish covering.
- At the corresponding complete set remove the antenna of an emergency call (E-call) on the right side of a body.
- Installation is made upside-down, track correctness of landing of a bumper concerning a door of a back and the back combined lamps.
|
|
Models of a basic equipment without external holder of a spare wheel
Details of installation of a rear bumper on models standard (not AMG) complete sets, equipped with the external holder of a spare wheel
|
|
- Details of installation of a rear bumper on models standard (not AMG) complete sets, equipped with the external holder of a spare wheel are shown on сопр. an illustration to which all references which are found in the text belong.
- At the corresponding complete set disunite the contact socket of an antenna cable of system of an emergency call (E-call) which is located under a side overlay of the right rack With in a poddomkrachivaniye point.
- Give nuts (A) and (In) on the car bottom behind a cross beam of a frame.
- Turn out bolts of fastening of console arms (D) holder of a spare wheel.
|
|
The bolts fixed by means of nuts (A) can be pushed out from the back party of a cross beam. |
- Remove console arms (D) holder of a spare wheel (see the Section Removal and installation of the external holder of a spare wheel (at the corresponding complete set)).
- Carefully remove 3 bumper panels, - try not to damage a paint and varnish covering and clamps.
- At the corresponding complete set give a nut of a back mud-chipper.
- Having against the stop taken away to the holder of the spare wheel back, give back and accurately remove a bumper, - try not to damage a paint and varnish covering.
- At the corresponding complete set remove the antenna of an emergency call (E-call) on the right side of a body.
- Installation is made upside-down, track correctness of landing of a bumper concerning a door of a back and the back combined lamps.
|
|
AMG complete set models
Details of installation of a rear bumper on AMG complete set models
|
|
- Details of installation of a rear bumper on models of a complete set of AMG are shown on сопр. an illustration to which all references which are found in the text belong.
- At the corresponding complete set disunite the contact socket of an antenna cable of system of an emergency call (E-call) which is located under a side overlay of the right rack With in a poddomkrachivaniye point.
- Turn out screws (A) of fastening of assembly brackets of an udaropoglotitel to the lower part of a cross beam.
- Remove a decorative slip (Velkro) and turn out the screws (V) located on the upper edge of a bumper.
- Having given back, accurately remove a bumper, - try not to damage a paint and varnish covering and an electrical wiring, - at the corresponding complete set remove a rubber sealant at the left on a body and disunite the contact socket of an electrical wiring of the Parktronic system.
- At the corresponding complete set remove the antenna of an emergency call (E-call) on the right side of a body.
- Installation is made upside-down, track correctness of landing of a bumper concerning a door of a back and the back combined lamps.
|
|
