106fb49f

5.2.12. Removal and installation of the sensor of temperature of external air, - except models 163.128

Details of installation of the sensor of temperature of external air

Details of installation of the sensor of temperature of external air

Shooters — Screws of fastening of the dashboard to racks And


 PERFORMANCE ORDER

  1. Details of installation of the sensor of temperature of external air are shown on illustrations to which all references which are found in the text belong.
  2. Empty the cooling system (see the Head of the Power supply system and production of the fulfilled gases).
  3. Turn out fixing bolts and remove a broad tank of the cooling system (1) from a back partition of a motive compartment.
  4. Disconnect hoses of a cooling path (2) from the heater heat exchanger.
  5. In the conditions of a workshop of car service make a discharge of the air conditioning system.
  6. Uncover the broad valve (4).
  7. Give a nut (3) fastenings of the broad valve (4).
  8. Disconnect refrigerator lines from the broad valve.
  9. Remove assembly of the drive of screen wipers.
  10. Give nuts (5) dashboards on a partition of a motive compartment.
  11. Remove panels of finishing of racks And.
  12. Give the plastic nuts of the panel of fastening of the panel of finishing located at the left under the dashboard.
  13. Remove the panel of finishing of a foot well.
  14. Remove rubber caps and turn out screws of fastening of panelipribor to racks And (shooters).
  15. Remove assembly of the central console (see the Head Kuzov).
  16. Turn out a bolt (6) under the dashboard.
  17. Delay the dashboard back and develop so that access to its back party opened.
  18. Disunite the contact socket of an electrical wiring (B10/5x1) of the sensor of temperature of external air.
  19. Disconnect the cable going from the sensor to a heater air/heat exchanger conditioner evaporator casing.
  20. Take the sensor of temperature of external air (B10/5) from an air sleeve.
  21. Installation is made upside-down, - gas station of air conditioning system should be made in the conditions of a workshop of car service.
  22. In conclusion check the cooling system for existence of signs of development of leaks.