13.2.16. Removal and installation of a back seat
Details of installation double (60%) sections of a dual back seat on release models till 31.08.99
|
|
- Details of installation double (60%) are shown till 31.08.99 to section of a dual back seat on release models on an illustration to which all references which are found in the text belong.
- Remove head restraints.
- Release clamps and uncover (1) the left support of a seat.
- Turn out fixing bolts (2), remove two-section section of a back seat and take it through a back door.
- Installation is made upside-down, - replace fixture, grease a carving of bolts before installation with special sealant for fixing of threaded connections.
|
|
Release models from 01.09.99
Details of installation double (60%) sections of a dual back seat on release models from 01.09.99
|
|
- Details of installation double (60%) are shown from 01.09.99 to section of a dual back seat on release models on an illustration to which all references which are found in the text belong.
- Remove head restraints.
- Remove the lower covers (4) (only from two-section section).
- Give fixing bolts (2) and nuts (3).
- Turn out bolts from the back party of single section of a seat, - frames of sections are imposed at each other.
- Remove two-section section and take it through a back door.
- Installation is made upside-down, - replace fixture, grease a carving of bolts before installation with special sealant for fixing of threaded connections.
|
|
Single (40%) seat section
Release models till 31.08.99
Details of installation single (40%) sections of a dual back seat on release models till 31.08.99
|
|
- Details of installation single (40%) are shown till 31.08.99 to section of a dual back seat on release models on an illustration to which all references which are found in the text belong.
- Remove a head restraint.
- Remove the lower cover (3).
- Turn out forward fixing screws (1).
- Put a seatback forward.
- Omit assembly of a seat on a floor.
- Turn out back fixing screws (2) and remove single section of a seat.
- Installation is made upside-down, - replace fixture, grease a carving of bolts before installation with special sealant for fixing of threaded connections.
|
|
Release models from 01.09.99
Details of installation single (40%) sections of a dual back seat on release models from 01.09.99
|
|
- Details of installation single (40%) are shown from 01.09.99 to section of a dual back seat on release models on an illustration to which all references which are found in the text belong.
- Remove a head restraint.
- Remove the lower cover (4) (only from single-section section).
- On the models equipped with back side safety cushions disconnect an electrical wiring from a buckle of a seat belt and disconnect the plait attached to a seat frame by an adhesive tape.
- Turn out forward fixing bolts (1).
- Put a seatback forward.
- Omit assembly of a seat on a floor.
- Turn out back fixing bolts (2) and remove single section of a seat.
- Installation is made upside-down, - replace fixture, grease a carving of bolts before installation with special sealant for fixing of threaded connections.
|
|
