13.2.17. Removal and installation of seatbacks
Details of installation of a back of a front seat (model with the electric drive of front seats and without function of storing of situation)
Details of installation of a back of a front seat (model with the electric drive of front seats and with function of storing of situation)
|
|
- Details of installation of a back of a front seat are shown on illustrations to which all references which are found in the text belong.
- Remove assembly of a seat (see the Section Removal and installation of panels of a carpet of a floor).
- Remove side panels of finishing of a frame and, - at the corresponding complete set, - disunite contact sockets of an electrical wiring of a thermoelectric heating element (3) and the module of management of adjustment (N32/1 or N32/2) (4).
- Turn out screws (2) fastenings of a back (1) and remove the last from assembly of a seat.
- Installation is made upside-down, - track correctness of laying of an electrical wiring.
|
|
Back seat
Release models till 31.08.99
Details of installation of backs of a two-section back seat on release models till 31.08.99
|
|
- Details of installation of backs of a back seat on release models are shown till 31.08.99 on an illustration to which all references which are found in the text belong.
- Weaken a seat cover for the purpose of ensuring access to overlays of support of backs (2 and 3).
- Turn out screws (1) of fastening of the top slips (2).
- Having hooked, remove the lower slips (3).
- Turn out screws (4 and 5) of fastening left (9) and the right (11) backs of a back seat to the support (8 and 10).
- Turn out screws of fastening of buckles of seat belts and release anchor knots of belts so to provide access to screws (7) arms of backs.
- Turn out screws (7) and remove backs.
|
|
At removal of the left and right backs delay outside their side support. |
- Installation is made upside-down
|
|
Release models from 01.09.99
Details of installation of backs of a two-section back seat on release models till 31.08.99
|
|
- Details of installation of backs of a back seat on release models are shown from 01.09.99 on an illustration to which all references which are found in the text belong.
- Uncover half of the luggage compartment.
- Lower the seat section which is not subject to dismantling in a foot well.
- When dismantling double section turn out two fixing bolts, unbend an upholstery, release back clamps and remove the pillow established under an armrest (1).
- Turn out fixing bolts (2) and remove side slips (3) support of a back.
- Turn out bolts (4) of a basic arm of a back, when dismantling double section previously lower a back for the purpose of ensuring access to screws from the inside of an arm.
- Lower the served back section in a foot well.
- Lower the handle of the regulator forward and turn out the screw (5) of fastening of a back to an external support.
- On double section disconnect an upholstery from the back party of a pillow (9), lift up an upholstery and turn out the screw (8) of fastening of anchor knot (10) of a seat belt (7) to a seat frame. At the corresponding complete set (back side safety cushions) remove from a frame of a seat and release the contact socket of an electrical wiring from the holder, then remove a seat belt buckle,
- Remove a back (6).
- Installation is made upside-down.
|
|
