11:17. Removal and installation of hummock assembly of the drive of the parking brake
|
|
In total самоконтрящиеся bolts and nuts are subject to replacement without fail! |
Forward cable
Details of installation of a pedal of raising of the parking brake
|
|
- Details of installation of forward section of hummock assembly of the drive of the parking brake are shown on an illustration to which all references which are found in the text belong.
- Make a preliminary tightness of the regulator of a weak point (the compensation lever) of a driving cable.
- Disconnect a cable (85) from the intermediate lever (91) and by means of adaptation (043) release it from a clamp on the floor panel.
- Uncover, established at the left under the dashboard.
- Remove the carpet panel.
- By means of adaptation (043) disconnect a cable (85) from a pedal of the parking brake (75), - try not to drop a rubber ring (85s).
- Having given a nut, weaken a cable cover in a foot well.
- Remove a clamp (85a) and push a cable through the plug through passage (85b) in the transmission tunnel.
- Installation is made upside-down. In conclusion unload the weak point regulator (the compensation lever) and make adjustment of the drive of the parking brake (see the Section Adjustment of the Drive of the Parking Brake).
|
|
Back cable
Details of installation of back section of hummock assembly of the drive of the parking brake
|
|
- Details of installation of back section of hummock assembly of the drive of the parking brake are shown on an illustration to which all references which are found in the text belong.
- Take off boots of the parking brake (see the Section Replacement of Boots of the Parking Brake).
- Disconnect a cable (86) from the compensation lever (92).
- By means of adaptation (043) release a cable (86) from clamps on floor panels.
- Release a cable (86) from stupichny assembly.
- Installation is made upside-down.
|
|
