4.5.13. Removal and installation of a damper of tortional fluctuations / pulley of a driving belt
Details of installation of a damper of tortional fluctuations / pulley of a driving belt of the engine of a series 612
|
|
- Details of installation of a damper of tortional fluctuations / a pulley of a bent shaft of the engine of a series 612 are shown on an illustration to which all references which are found in the text belong.
- Take off a belt of the drive of auxiliary units (1).
- By means of special adaptation (3) block a gear wreath of a flywheel / a driving disk.
- Turn out the central bolt (4) and remove it together with a dish-shaped washer (5).
- By means of a dvukhnozhechny stripper remove assembly a pulley/damper of tortional fluctuations (6).
- Attentively study a condition of a nave of a damper/pulley, in case of need make replacement.
- Replace a forward epiploon of a bent shaft (see the Section Removal and installation of an electric motor of shutdown of inlet port (the series 612 engine)).
- Installation is made upside-down.
|
|
M628
Details of installation of a damper of tortional fluctuations / pulley of a driving belt of the engine of a series 628
|
|
- Details of installation of a damper of tortional fluctuations / a pulley of a bent shaft of engines of a series 628 are shown on an illustration to which all references which are found in the text belong.
- Remove the lower section of a noise isolation.
- Remove the electric fan of the cooling system.
- Install the screen of protection of the К/В radiator/condenser.
- Remove an air sleeve of the right lower air pipeline / cooler of a path of pressurization of air.
- Take off a belt of the drive of auxiliary units.
- Disconnect hoses of a cooling path from the water pump.
- Holding a pulley from a provorachivaniye by means of adaptation (2), turn out the central bolt (1).
- Having in case of need hooked the suitable screw-driver, remove a damper of tortional fluctuations / a pulley (3).
- Installation is made upside-down.
|
|
